The instrument LAS for a demineralized water production monitoring indicates permanently the resistivity value. The alarm sounds each time the resistivity is lower than the pre-set value; it reset only when the resistivity is back to a greater value. The scale 0 ... 2 MOhm.cm is expanded to allow a comfortable reading from 20 to 500 kOhm.cm with centered value at 100 kOhm.cm bringing a safe information. The instrument is convenient for monitoring demineralisation systems anions / cations, without automatic control. Associated probes: a probes with cell factor 0.1 are suitable, however the probe BC 1425/BNC is particularly convenient.

• Measuring range 0to 2 MOhm.cm, expanded scale centered on 100 kOhm.cm
• Alarm Audible alarm and red light on the front
• Output Changeover contact
• Switching power 5 A - 250 V AC; 5 A - 30 V DC
• Housing In ABS - 80 x 160 x 55 mm
• Power supply 230 V AC - 50 Hz (1.5 m long cable included)
• EC Conformity: The instrument meets the legal requirements

In combination with a conductivity cells, BAMOPHAR 323 is designed for conductivity or resistivity measurements. Examples: conductivity on drinkable and ground water, conductivity in cooling tower, resistivity on demineralized water, control of ultra pure water production units.

The device is equipped with a color touch screen for the display of a multilingual menu friendly and intuitive. It provides easy reading of measurement, temperature and state of the thresholds. It displays a menu with all parameters for configuration of analogue outputs, thresholds set up and regulation mode. In order to facilitate its commissioning, a programming menu can simulate the measurement, acting on the analog outputs, as well as on the thresholds.

BAMOPHAR 323 displays an absolute or compensated temperature measurement. An extension terminal allows a second measuring parameter (pH, flow-rate, turbidity, etc.). Data from this blind device displayed on the main unit.

• Color touch screen
• Programmable ranges:
• From 0-200 Ohm.cm up to 0-200 MOhm.cm
• From 0-2 mcS/cm up to 0-20 mS/cm
• Associated measuring cells:
• Cell factors: 10 - 1 - 0.1 - 0.01
• Temperature compensation
• Automatic or manual compensation
• 2 outputs 0/4-20 mA, configurable
• 4 relays (Thresholds, alarm)
• Options:
• RS422/ J-BUS + LOGGER
• Extension terminal for 2nd measuring parameter

Conductivity measurement for monitoring and/ or regulation in water treatment, chemical industries, industrial applications: cooling towers survey, clean water control (wells, drinking water, thermal baths ...), stormwater and runoff water survey, WWTP survey, concentration measurements of acid and base, chemicals quality survey.

BAMOPHAR displays on a color touch-sensitive screen a multilingual friendly using menu. The reading is easy for measurement, temperature and relay status. Conductivity and temperature values are available as well from outputs 4-20 mA. A complete system includes: Inductive probe, cable output, Probe holder for immersion or on-line application, Converter, factory calibrated, 1 Monitor BAMOPHAR 364.

Extension terminal for 2nd measuring parameter allows a second measuring parameter (pH, flow-rate, turbidity, etc.). Data from this blind unit are displayed on the main unit.